메뉴 건너뛰기
.. 내서재 .. 알림
소속 기관/학교 인증
인증하면 논문, 학술자료 등을  무료로 열람할 수 있어요.
한국대학교, 누리자동차, 시립도서관 등 나의 기관을 확인해보세요
(국내 대학 90% 이상 구독 중)
로그인 회원가입 고객센터 ENG
주제분류

추천
검색
질문

논문 기본 정보

자료유형
학술저널
저자정보
최해찬 (홍익대학교) 신승원 (홍익대학교)
저널정보
한국전산유체공학회 한국전산유체공학회지 한국전산유체공학회지 제22권 제4호
발행연도
2017.12
수록면
109 - 115 (7page)
DOI
10.6112/kscfe.2017.22.4.109

이용수

표지
📌
연구주제
📖
연구배경
🔬
연구방법
🏆
연구결과
AI에게 요청하기
추천
검색
질문

이 논문의 연구 히스토리 (6)

초록· 키워드

오류제보하기
Droplet jumping process on superhydrophobic surface draw quite an attention lately for extending the duration of dropwise condensation which enhance the heat transfer considerably compared to filmwise condensation. Most researches so far have been focused on analyzing the behavior of merged droplets. During the phase change, higher temperature gradient can be expected near the wall thus interface movement from condensation effect could be much greater compared to the top. This would increase the asymmetry of the surface which will induce drop jumping process. In this paper, we will focus on single droplet jumping from initial asymmetric geometry on superhydrophobic surface. To see the clear distinction of the initial geometric effect, only hydraulic part of the simulation was considered. Interface was numerically tracked by Level Contour Reconstruction Method. Effect from initial contact angle and radius of the droplet was analyzed based on related energy changes during the process. Droplet jumping occurs when the initial contact angle is lower than approximately 120°. We also found that lower initial contact angle has high conversion rate for the kinetic energy thus exhibiting higher jumping velocity. And lowering the radius is also resulting in higher jumping velocity.

목차

1. 서론
2. 수치해석 방법
3. 수치해석 결과 및 분석
4. 결론
References

참고문헌 (11)

참고문헌 신청

함께 읽어보면 좋을 논문

논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!

이 논문의 저자 정보

이 논문과 함께 이용한 논문

최근 본 자료

전체보기

댓글(0)

0

UCI(KEPA) : I410-ECN-0101-2018-559-001740268