지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술저널
- 저자정보
- 발행연도
- 2022.12
- 수록면
- 3,145 - 3,159 (15page)
- DOI
- 10.1007/s12540-022-01192-x
이용수
초록· 키워드
오류제보하기
Particle-reinforced aluminum matrix composites (PRAMCs) always show a low forming stability because the particles areeasily separated from the matrix, leaving voids and forming cracks. Extruded in situ PRAMCs are gradually replacing ex situPRAMCs due to the higher interface bonding between the in situ reinforcements and matrix. In this study, a hot-extrudedin situ AA6111 composite with ZrB2nanoparticles was obtained from an Al-Zr-B system. The effects of the ZrB2contenton the geometrically necessary dislocation (GND) density, grain size, grain boundaries, textures and tensile properties ofAA6111 composites were researched. The results showed that as the volume fraction of ZrB2increased, the mean GNDdislocation density increased from 1.53 × 1015m−2 to 3.23 × 1015m−2, and most dislocations were located around the ZrB2nanoparticle clusters. In addition, an increase in the ZrB2content decreased the frequency of high-angle grain boundaries(HAGBs) from 79.28 to 69.45% and increased the frequency of low-angle grain boundaries (LAGBs). ZrB2nanoparticleclusters which were located along the grain boundaries promoted continuous dynamic recrystallization (CDRX) and remarkablyrefined the grains, with the mean size decreasing from 48.2 to 1.8 μm. However, dispersed ZrB2nanoparticles inside thegrains suppressed CDRX. Tensile tests showed that the properties rose dramatically with an increasing volume fraction ofZrB2,and the optimum ultimate tensile strength (UTS), yield strength (YS) and elongation (El) of the 2 vol% ZrB2/AA6111composite were 365 MPa, 280 MPa, and 25.6%, respectively. The mechanisms for CDRX, strengthening and plasticityenhancement were determined and discussed.
목차
등록된 정보가 없습니다.
참고문헌 (0)
참고문헌 신청함께 읽어보면 좋을 논문
논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!
-
Effect of hybrid ceramic addition on Al7075 for prompt utilization
Journal of Ceramic Processing Research
2023 .06
-
TPU/CNT/ZrB₂ 복합체 전도성 필라멘트 개발
대한용접학회 특별강연 및 학술발표대회 개요집
2023 .10
-
Densification and properties of in-situ synthesized ZrB2- SiC composities from ZrO2, B4C and SiC system
Journal of Ceramic Processing Research
2017 .04
-
Effect of SiC and WC additon on Oxidation Behavior of Spark-Plasma-Sintered ZrB2
한국분말야금학회지
2019 .01
-
Investigations on aluminium hybrid composites reinforced with ZrB2/Al2O3/Multi-Walled Carbon Nanotube (MWCNT) for aerospace applications
Journal of Ceramic Processing Research
2020 .01
-
Mechanical Properties of Al-TiB₂-ZrB₂HybridMetalMatrixComposites
한국기계가공학회 춘추계학술대회 논문집
2017 .04
-
Effects of gelation temperature, water, polyethylene glycol on morphology of ZrB2 particles synthesized by sol-gel method
Journal of Ceramic Processing Research
2018 .08
-
Quasi-nanocrystalline ZrB2 powder synthesized by saltassisted combustion and its formation mechanism
Journal of Ceramic Processing Research
2024 .08
-
Oxidation behavior of C/C composites with B4C-SiCZrC-ZrB2 coating prepared by infiltration and pyrolysis
Journal of Ceramic Processing Research
2021 .01
-
Nucleation Mechanism of Discontinuous Dynamic Recrystallization with Restrained Grain Boundary Sliding
Metals and Materials International
2021 .12
-
Uncovering Microstructure Evolution and Dynamic Softening Mechanism of Spray-Deposited AlZnMgCu Alloy Under Thermal Deformation
Metals and Materials International
2022 .09
-
Effects of Grain Boundary on {100} Recrystallization Texture of High Silicon Electrical Steel
Metals and Materials International
2018 .01
-
Effect of serrated grain boundary on stress corrosion cracking of Alloy 600
Nuclear Engineering and Technology
2018 .01
-
유역분할 알고리즘을 이용한 결정립 크기 측정
한국표면공학회지
2022 .12
-
Radiation induced grain boundary segregation in ferritic/martensitic steels
Nuclear Engineering and Technology
2020 .01
-
Grain Refinement of CoNiCrMo Non-equiatomic Medium Entropy Alloy
Metals and Materials International
2023 .01
-
Bimodal-Structured Al?Mg Alloy with High Strength and Ductility Processed by High Strain Rate Rolling at Medium Temperature
Metals and Materials International
2021 .12
-
Microstructural and Wear Behaviour of Al 6063?W Nanocomposites Developed Using Friction Stir Processing
Metals and Materials International
2021 .12
-
Hot Tensile Deformation Behavior of Twin Roll Casted 7075 Aluminum Alloy
Metals and Materials International
2015 .01
-
Microstructure Evolution and Dynamic Precipitation Behavior of Mg?10Gd?4Y?1Sm?0.5Zr Alloy During Backward Hot Extrusion
Metals and Materials International
2021 .09
이 논문의 저자 정보
최근 본 자료
댓글(0)
0