Review on the Influence of Different Reinforcements on the Microstructure and Wear Behavior of Functionally Graded Aluminum Matrix Composites by Centrifugal Casting

Bassiouny Saleh; Jinghua Jiang; Aibin Ma; Dan Song; Donghui Yang; Qiong Xu

추천

검색

자료유형: 학술저널

저자정보: Bassiouny Saleh (Hohai University) Jinghua Jiang (Hohai University) Aibin Ma (Hohai University) Dan Song (Hohai University) Donghui Yang (Hohai University) Qiong Xu (Hohai University)

저널정보: 대한금속·재료학회 Metals and Materials International Metals and Materials International Vol.26 No.7

발행연도: 2020.1

수록면: 933 - 960 (28page)

이용수

📌

연구주제

📖

연구배경

🔬

연구방법

🏆

연구결과

초록· 키워드

오류제보하기

The main objective of the present paper is to draw the attention of researchers towards the wear analysis of functionallygraded aluminum matrix composites (FGAMCs) reinforced with different types of particles. The quality of the productsand characteristics achieved by the functionally graded materials (FGMs) has been given increasing attention during recentdecades. FGMs provide a way to obtain gradients between two phases with variations of properties. The centrifuge castingprocess was used to produce continuous variation of graded materials. These continuous graded materials offer high strengthand enhanced wear resistances compared with traditional composite materials. This paper summarizes the effect of the variousreinforcement materials and wear test parameters on microstructure as well as wear properties in the FGAMCs obtainedthrough the centrifugal casting technique. The results found in the reviewed literature are classified according to types ofreinforcement particles (such as silicon carbide, alumina and boron carbide) and the influence of wear test parameters (suchas applied load, sliding distance, duration and sliding speed) on FGM composites. The main conclusions in this paper arederived from previous studies on experimental investigations on the wear characteristics of FGAMCs. The research gapsand future directions have been discussed which will be prolific to the researchers in the design and manufacture of FGMsproduction by centrifugal casting.

#Metal matrix composites (MMCs) · Functionally graded materials (FGMs) · Centrifugal casting · Sliding wear · Aluminium alloy · Ceramic reinforcement

참고문헌 (139)

참고문헌 신청

S. Maimunnisa / 2018 / Role of Centrifugal Casting on Electrochemical Corrosion Behavior of A356-SiCp Composite in 3.5 wt.% NaCl / Journal of Materials Engineering and Performance 27(8):4210~4224

L. Ceschini / 2011 / Advances in Metal Matrix Composites / Trans Tech Publications Ltd

T. P. D. Rajan / 1998 / J. Mater. Sci 3:3491

Pankaj Kumar Gupta / 2018 / Fabrication of Ceramic Reinforcement Aluminium and Its Alloys Metal Matrix Composite Materials: A Review / Materials Today: Proceedings 5(9):18761~18775

J. Y. Fakruddinali / 2015 / Ind. J. Sci. Res. Technol 3:34

함께 읽어보면 좋을 논문

논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!