Wear Resistant Duplex Stainless Steels Produced by Spray Forming

Juliano Soyama; Thiago Pama Lopes; Guilherme Zepon; Claudio Shyinti Kiminami; Walter José Botta; Claudemiro Bolfarini

추천

검색

자료유형: 학술저널

저자정보: Juliano Soyama (Universidade Federal de São Carlos (UFSCar)) Thiago Pama Lopes (Universidade Federal de São Carlos (UFSCar)) Guilherme Zepon (Universidade Federal de São Carlos (UFSCar)) Claudio Shyinti Kiminami (Universidade Federal de São Carlos (UFSCar)) Walter José Botta (Universidade Federal de São Carlos (UFSCar)) Claudemiro Bolfarini (Universidade Federal de São Carlos (UFSCar))

저널정보: 대한금속·재료학회 Metals and Materials International Metals and Materials International Vol.25 No.2

발행연도: 2019.1

수록면: 456 - 464 (9page)

이용수

📌

연구주제

📖

연구배경

🔬

연구방법

🏆

연구결과

초록· 키워드

오류제보하기

In this work, boron-modified duplex stainless steels were prepared by spray forming using design guidelines provided bythermodynamic calculations. Firstly, an investigation of stable phases and phase formation sequence in duplex steels containinghigh levels of boron was conducted. The calculation indicated that there was an eutectic point at around 1 wt% boron withdifferent primary phase formations upon equilibrium solidification. For hypoeutectic compositions, the primary phase wasδ-Ferrite, whereas for hypereutectic a metallic boride (M2B) should form. Additionally, eutectic reactions for both compositionsshould lead to the formation of borides M2Band M3B2. Secondly, spray forming experiments were conducted basedon the thermodynamic calculations. Sample preparation was carried out using a conventional superduplex steel (2507) asstarting material. Two different compositions were selected: one hypoeutectic (0.8 wt% B) and one hypereutectic (2.5 wt%B). The microstructural investigation revealed the formation of different types of borides embedded in an austenitic-ferriticmatrix. Finally, the wear resistance was evaluated with the dry sand/rubber wheel test and a significant improvement wasobserved for boron-containing steels in comparison with the same steel without boron. This improvement was attributed tothe presence of fine and well-distributed boride particles that protected the austenitic-ferritic matrix from material removal.

#Thermodynamic calculations · Spray forming · Stainless steel · Boron · Wear

참고문헌 (37)

참고문헌 신청

P. J. E. Monson / 1990 / Surf. Eng 6:185

안동규 / 2013 / Hardfacing Technologies for Improvement of Wear Characteristics of Hot Working Tools: A Review / International Journal of Precision Engineering and Manufacturing 14(7):1271~1283

Z. Wang / 2015 / J. Alloys Compd 650:918

E. Sigolo / 2016 / Surf. Coat. Technol 302:255

A. A. Azarkevich / 1995 / Met. Sci. Heat Treat 37:22

함께 읽어보면 좋을 논문

논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!