지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술저널
- 저자정보
- 저널정보
- 한국유체기계학회 International Journal of Fluid Machinery and Systems International Journal of Fluid Machinery and Systems Vol.10 No.3
- 발행연도
- 2017.9
- 수록면
- 287 - 295 (9page)
- DOI
- 10.5293/IJFMS.2017.10.3.287
이용수
초록· 키워드
오류제보하기
The most detrimental pressure pulsations in high-head pump-turbines is caused by the rotor-stator interaction (RSI) between the guide vanes and runner blades. When the pump-turbine operates in the S-shaped region of the characteristic curves, the deteriorative flow structures may significantly strengthen RSI, causing larger pressure pulsations and stronger vibration with an increased risk of mechanical failure. CFD simulations were carried out to analyze the impacts of flow evolution on the pressure pulsations in the S-shaped region of a model pump-turbine. The results show that the reverse flow vortex structures (RFVS) at the runner inlet have regular development and transition patterns when discharge reduces from the best efficiency point (BEP). The RFVS first occur at the hub side, and then shift to the midspan near the no-load point, which cause the strongest pressure pulsations. The locally distributed RFVS at hub side enhance the local RSI and makes the pressure fluctuations at the corresponding sections stronger than those at the rest sections along the spanwise direction. Under the condition of RFVS at the mid-span, the smaller flow rate make the smaller difference of pressure pulsation amplitudes in the spanwise direction. Moreover, the rotating stall, rotating at 35.7%-62.5% of the runner rotational frequency, make the low frequency components of pressure pulsations distribute unevenly along the circumference in the vaneless space. However, it have little influence on the distributions of high components.
목차
Abstract
1. Introduction
2. Numerical setup
3. Results and Analysis
4. Conclusions
References
참고문헌 (0)
참고문헌 신청함께 읽어보면 좋을 논문
논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!
-
Investigation of Pressure Pulsations and Flow Instabilities in a Centrifugal Pump at Part-load Conditions
International Journal of Fluid Machinery and Systems
2017 .12
-
An Experimental Investigation of the Air Injection Effect on the Vortex Structure and Pulsation Characteristics in the Francis Turbine
International Journal of Fluid Machinery and Systems
2020 .03
-
Simulation and Test of Gear Pump Flow Pulsation
International Journal of Fluid Machinery and Systems
2018 .09
-
사류펌프의 압력맥동특성 분석
한국유체기계학회 논문집
2020 .10
-
Investigation of Unsteady Pressure Pulsation and Internal Flow in a Centrifugal Pump under Low Flow Rate
International Journal of Fluid Machinery and Systems
2019 .09
-
압력맥동측정장치를 통한 펌프 유량맥동 측정 및 해석모델 개발
유공압건설기계학회 학술대회논문집
2016 .06
-
Research on non-uniform pressure pulsation of the diffuser in a nuclear reactor coolant pump
Nuclear Engineering and Technology
2021 .03
-
On the High-partial-load Pulsation in Francis Turbines
International Journal of Fluid Machinery and Systems
2019 .09
-
아이들 조건에서 자동변속기 밸브바디의 압력 맥동 현상에 대한 연구
한국자동차공학회 추계학술대회 및 전시회
2017 .11
-
Dynamic evolutions between the draft tube pressure pulsations and vortex ropes of a Francis turbine during runaway
International Journal of Fluid Machinery and Systems
2017 .12
-
Experimental and Numerical Studies on Flow Characteristics of Centrifugal Pump under Air-water Inflow
International Journal of Fluid Machinery and Systems
2019 .03
-
Experimental and numerical investigation on the pressure pulsation in reactor coolant pumps under different inflow conditions
Nuclear Engineering and Technology
2023 .04
-
Analysis of coasting-down hydrodynamic characteristics of sodium pump in the primary circuit of fast reactor
International Journal of Fluid Machinery and Systems
2022 .06
-
초고압 복열 플런져 펌프의 댐퍼 전/후 맥동 측정에 관한 연구
한국정밀공학회 학술발표대회 논문집
2019 .05
-
Instability Prediction of Valve Motion and Internal Flow in Novel Large-scale Reciprocating Pump
International Journal of Fluid Machinery and Systems
2019 .03
-
Natural Flow Characteristics of Liquid Rocket Engine Turbopump during Startup
International Journal of Fluid Machinery and Systems
2022 .09
-
파워유닛의 맥동 현상 측정 실험에 관한 연구
유공압건설기계학회 학술대회논문집
2020 .12
-
가변 사판식 피스톤펌프의 맥동 변수 분석 및 최적 밸브플레이트 노치 설계를 위한 압력 및 유량맥동에 관한 연구
한국생산제조학회지
2015 .04
-
A Study on Numerical Methods for Performance Prediction of Tidal Turbines
AFORE
2024 .11
-
Numerical Analysis of Standard - Unstandard Gears for an External Gear Pumps
International Journal of Fluid Machinery and Systems
2021 .03
이 논문의 저자 정보
최근 본 자료
댓글(0)
0
UCI(KEPA) : I410-ECN-0101-2018-554-001894735