지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술저널
- 저자정보
- 저널정보
- 한국콘크리트학회 International Journal of Concrete Structures and Materials International Journal of Concrete Structures and Materials Vol.11 No.1
- 발행연도
- 2017.3
- 수록면
- 69 - 84 (16page)
이용수
초록· 키워드
오류제보하기
This paper presents results of an experimental investigation on the behaviour of bond between external glass fibre reinforced polymer reinforcement and concrete exposed to three different environmental conditions, namely, temperature cycles, wet–dry cycles and outdoor environment separately for extended durations. Single shear tests (pull-out test) were conducted to investigate bond strengths (pull-out strengths) of control (unexposed) and exposed specimens. Effect of the exposure conditions on the compressive strength of concrete were also investigated separately to understand the effect of changing concrete compressive strength on the pull-out strength. Based on the comparison of experimental results of exposed specimens to control specimens in terms of bond strengths, failure modes and strain profiles, the most significant degradation of pull-out strength was observed in specimens exposed to outdoor environment, whereas temperature cycles did not cause any deterioration of strength.
목차
Abstract
1. Introduction
2. Experimental Program
3. Test Results and Discussion
4. Conclusions
References
참고문헌 (34)
참고문헌 신청
Al-Tamimi, A. K., Hawileh, R. A., Abdalla, J. A., Rasheed, H. A., & Al-Mahaidi, R. (2014). Durability of the bond between CFRP plates and concrete exposed to harsh environments. Journal of Materials in Civil Engineering, 27, 04014252.
AS 1012.17. (1997). Method of testing concrete?Determination of the static chord modulus of elasticity and Poisson’s ratio of concrete specimens. Sydney, Australia: Standards Australia.
AS 1012.9. (1999). Method of testing concrete?Determination of the compressive strength of concrete specimens. Sydney, Australia: Standards Australia.
ASTM D3039/D3039M. (2008). Standard test method for tensile properties of polymer matrix composite materials. Pennsylvania: American Society for Testing and Materials (ASTM).
Benzarti, K., Chataigner, S., Quiertant, M., Marty, C., & Aubagnac, C. (2011). Accelerated ageing behaviour of the adhesive bond between concrete specimens and CFRP overlays. Construction and Building Materials, 25, 523?538.
함께 읽어보면 좋을 논문
논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!
-
An experimental investigation on effect of elevated temperatures on bond strength between externally bonded CFRP and concrete
Steel and Composite Structures, An International Journal
2019 .01
-
콘크리트의 형상비 및 온도변화에 따른 부착강도 특성평가
한국도로학회논문집
2018 .01
-
저강도 콘크리트의 부착강도 평가를 위한 인발실험
한국콘크리트학회 학술대회 논문집
2024 .11
-
Effect of high temperature on the bond performance between steel bars and recycled aggregate concrete
Computers and Concrete, An International Journal
2019 .01
-
반복하중이 철근콘크리트구조의 부착 강도에 미치는 영향
한국콘크리트학회 학술대회 논문집
2021 .05
-
Local bond-slip behavior of medium and high strength fiber reinforced concrete after exposure to high temperatures
Structural engineering and mechanics : An international journal
2018 .01
-
Local bond-slip behavior of medium and high strength fiber reinforced concrete after exposure to high temperatures
Structural Engineering and Mechanics, An Int＇l Journal
2018 .01
-
Development of Mapping Function to Estimate Bond-Slip and Bond Strength of RC Beams Using Genetic Programming
International Journal of Concrete Structures and Materials
2022 .11
-
Residual properties of high-strength fiber reinforced concrete after exposure to high temperatures
Computers and Concrete, An International Journal
2019 .01
-
Influence of Initial Damage Degree on the Degradation of Concrete Under Sulfate Attack and Wetting–Drying Cycles
International Journal of Concrete Structures and Materials
2020 .09
-
고강도 콘크리트를 적용한 얇은 RC 판부재의 정적 강도 안전성 평가
한국안전학회지
2017 .01
-
Prediction of the Tensile Strength of Normal and Steel Fiber Reinforced Concrete Exposed to High Temperatures
International Journal of Concrete Structures and Materials
2021 .11
-
Bond behavior between circular steel tube and high-strength concrete after elevated temperatures
Structural Engineering and Mechanics, An Int＇l Journal
2022 .12
-
Post-fire Bond Behaviors Between Grout and Steel Rebar
International Journal of Concrete Structures and Materials
2022 .09
-
Comparisons Between Pull-Out Behaviour of Various Hooked-End Fibres in Normal-High Strength Concretes
International Journal of Concrete Structures and Materials
2019 .05
-
Bond Strength of GFRP Bars Embedded in Engineered Cementitious Composite using RILEM Beam Testing
International Journal of Concrete Structures and Materials
2018 .01
-
Experimental investigation of natural bond behavior in circular CFTs
Steel and Composite Structures, An International Journal
2022 .01
-
Effect of specimen geometry and specimen preparation on the concrete compressive strength test
Structural engineering and mechanics : An international journal
2017 .01
-
Bond properties of steel and sand-coated GFRP bars in Alkali activated cement concrete
Structural Engineering and Mechanics, An Int＇l Journal
2020 .01
-
Application of internet of things for structural assessment of concrete structures: Approach via experimental study
Smart Structures and Systems, An International Journal
2023 .01
이 논문의 저자 정보
이 논문과 함께 이용한 논문
친수성 에폭시를 사용하여 FRP 시트로 보강된 슬래브의 휨거동 평가
주현진
,
한선진
,
조해창
외 2명
콘크리트학회 논문집
2016
.02
하중기반 유한요소모델에 의한 FRP 보강 철근콘크리트 기둥의 비선형 해석
조창근
콘크리트학회 논문집
2013
.10
Test of Headed Reinforcement in Pullout II : Deep Embedment
Dong-Uk Choi
International Journal of Concrete Structures and Materials
2006
.12
FRP 시트 및 강섬유 보강 콘크리트의 저속 충격에서의 휨 및 펀칭 파괴 거동
민경환
,
신현오
,
류두열
외 1명
콘크리트학회 논문집
2011
.02
차량 경량화를 위한 사출성형 유리섬유강화플라스틱의 온도 및 수분 흡수에 따른 기계적 물성 변화
천두만
,
안성훈
대한기계학회 논문집 A권
2013
.02
최근 본 자료
댓글(0)
0
UCI(KEPA) : I410-ECN-0101-2017-532-002243747