메뉴 건너뛰기
.. 내서재 .. 알림
소속 기관/학교 인증
인증하면 논문, 학술자료 등을  무료로 열람할 수 있어요.
한국대학교, 누리자동차, 시립도서관 등 나의 기관을 확인해보세요
(국내 대학 90% 이상 구독 중)
로그인 회원가입 고객센터 ENG
주제분류

추천
검색
질문

논문 기본 정보

자료유형
학술대회자료
저자정보
M. Koç (Virginia Commonwealth University) S. Mahabunphachai (Virginia Commonwealth University) J.E. Carsley (General Motors Research & Development Center)
저널정보
한국소성·가공학회 기타자료 NUMIFORM 2010
발행연도
2010.6
수록면
107 - 115 (9page)

이용수

표지
📌
연구주제
📖
연구배경
🔬
연구방법
🏆
연구결과
AI에게 요청하기
추천
검색
질문

초록· 키워드

오류제보하기
Material behavior of Al5754 was characterized using both tensile and hydraulic bulge tests under both room and warm temperature conditions. Response of Al5754 to different process conditions such as pressurization rates (0.022 and 0.2s<SUP>-1</SUP> strain rate), variable strain rates (increasing and decreasing profiles), forming temperature (room to 260℃), and loading conditions (uniaxial vs. biaxial) were presented. The results from tensile and hydraulic bulge tests as well as closed-die hydroforming experiments suggested that, in general, formability of Al5754 could be improved with slow forming rates (<0.02s<SUP>-1</SUP>), high forming temperature (>200℃), and biaxial loading (hydoforming) due to the delay of necking. However, decreasing forming rate conditions did not show any improvement in formability for temperature levels below 200℃.

목차

Abstract
INTRODUCTION
WARM HYDRAULIC BULGE TESTS
CLOSED-DIE WARM HYDROFORMING EXPERIMENTS
COMPARISON OF MATERIAL FLOW CURVES VIA FE SIMULATIONS
SUMMARY AND CONCLUSIONS
REFERENCES

참고문헌 (0)

참고문헌 신청

함께 읽어보면 좋을 논문

논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!

이 논문의 저자 정보

이 논문과 함께 이용한 논문

최근 본 자료

전체보기

댓글(0)

0

UCI(KEPA) : I410-ECN-0101-2014-550-003335540