지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술대회자료
- 저자정보
- 발행연도
- 2012.11
- 수록면
- 1,502 - 1,505 (4page)
이용수
초록· 키워드
오류제보하기
This paper is for virtual verification for automotive wire harness. The wire harness is one of typical power distribution components that are used to carry electrical power from the source to the remotely located loads. The wire system needs to perform in a safe manner when overload and short circuit conditions occur. The scope of simulation in this paper covers voltage & current analysis and circuit protection. GM Korea current procedure is to simulate the electric subsystem by Saber software and to confirm the CAE result by physical test. Also, i2t could be performed based on the real test result for single event. This process is helpful to produce higher reliable and robust design. General guideline is included for setting the boundary condition and component modeling.
목차
Abstract
1. INTRODUCTION
2. CAE ANALYSIS
4. CONCLUSION
References
참고문헌 (0)
참고문헌 신청이 논문의 저자 정보
이 논문과 함께 이용한 논문
최근 본 자료
댓글(0)
0
UCI(KEPA) : I410-ECN-0101-2014-556-000410120