지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술저널
- 저자정보
- 저널정보
- Korean Society for Precision Engineering International Journal of Precision Engineering and Manufacturing International Journal of Precision Engineering and Manufacturing Vol.9 No.2
- 발행연도
- 2008.4
- 수록면
- 3 - 7 (5page)
이용수
초록· 키워드
오류제보하기
Vibratory conveyors are widely used in industry to transport granular materials and products. A theoretical point mass model for vibratory conveying was studied. The results agreed well with experimental observations. The model theory included the resting, sliding and flight states of the material. Each state was considered separately when determining the equations of motion. For the coefficients of restitution, values of zero for the normal component and 0.8 for the tangential component were found to be appropriate for modeling the collisions of the granular particles with the conveying surface. The vibration angle had a large influence on the mode and rate of transport. There was an optimum vibration angle for a given set of conditions. The optimum vibration angle decreased and was better defined as the coefficient of friction increased. The results suggest the existence of an optimum dimensionless track acceleration (throw number), which does not support general industrial practice in which the track acceleration is limited when the feed cycle becomes erratic and unstable.
목차
1. Introduction
2. Theoretical Background
3. Experimental Setup and Procedures
4. Results and Discussion
5. Conclusions
REFERENCES
참고문헌 (13)
참고문헌 신청
1. [학술지(정기간행물)] - Sloot, E. M / 1996 / Theoretical and experimental study of the transport of granular materials by inclined vibratory conveyors / Powder Technology 87 (3) : 203 ~ 210
2. [학술지(정기간행물)] - Grochowski, R / 2004 / Reversing a granular flow on a vibratory conveyor / Applied Physics Letters 84 (6) : 1019 ~ 1021
3. [학술대회논문] - Kruelle, C, A / 2005 / Granular flow and pattern formation on a vibratory conveyor / Proceedings of Traffic and Granular Flow : 111 ~ 128
4. [학술지(정기간행물)] - El hor, H / 2005 / Model for transport of granular matter on an annular vibratory conveyor / Journal of Statistical Mechanics : 1 ~ 8
5. [학술지(정기간행물)] - James N.Keraita / 2007 / A Weighing Algorithm for Multihead Weighers / International Journal of Precision Engineering and Manufacturing 8 (1) : 21 ~ 26
2. [학술지(정기간행물)] - Grochowski, R / 2004 / Reversing a granular flow on a vibratory conveyor / Applied Physics Letters 84 (6) : 1019 ~ 1021
3. [학술대회논문] - Kruelle, C, A / 2005 / Granular flow and pattern formation on a vibratory conveyor / Proceedings of Traffic and Granular Flow : 111 ~ 128
4. [학술지(정기간행물)] - El hor, H / 2005 / Model for transport of granular matter on an annular vibratory conveyor / Journal of Statistical Mechanics : 1 ~ 8
5. [학술지(정기간행물)] - James N.Keraita / 2007 / A Weighing Algorithm for Multihead Weighers / International Journal of Precision Engineering and Manufacturing 8 (1) : 21 ~ 26
함께 읽어보면 좋을 논문
논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!
-
Power Current Control of a Resonant Vibratory Conveyor Having Electromagnetic Drive
JOURNAL OF POWER ELECTRONICS
2012 .07
-
Concepts and Design Aspects of Granular Models of Type-1 and Type-2
INTERNATIONAL JOURNAL of FUZZY LOGIC and INTELLIGENT SYSTEMS
2015 .06
-
Study on Optimum Design of Vibration Isolation Handles
Vibration Conference
1997 .11
-
Study on Optimum Design of Vibration Isolation Handles
한국소음진동공학회 국제학술발표논문집
1997 .01
-
Optimum Mesh Size for the Structural Vibration Analysis
Vibration Conference
1997 .11
-
Optimum Mesh Size for Structural Vibration Analysis
한국소음진동공학회 국제학술발표논문집
1997 .01
-
The dilatancy and numerical simulation of failure behavior of granular materials based on Cosserat model
Interaction and multiscale mechanics
2012 .01
-
Damage identification of belt conveyor support structure using periodic and isolated local vibration modes
Smart structures and systems
2015 .01
-
PARTICLE DAMPING WITH GRANULAR MATERIALS FOR MULTI-BODY SYSTEM
한국소음진동공학회 국제학술발표논문집
2008 .07
-
경계면이 입자유동 내 복합 사이즈의 입자 동적 거동에 미치는 영향
한국정밀공학회 학술발표대회 논문집
2008 .06
-
Dynamic Analysis of a Maglev Conveyor Using an EM-PM Hybrid Magnet
Journal of Electrical Engineering & Technology
2013 .11
-
The Relationship between Vibratory Sensation and Body Surface Vibration Induced by Complex Low-frequency Noise Composed of Two Pure Tones
한국소음진동공학회 국제학술발표논문집
2003 .08
-
급속여과공정에서의 효율적인 역세척방법 연구
대한환경공학회 학술발표논문집
1997 .12
-
DEVELOPMENT OF MASS AND LENGTH MEASUREMENT SYSTEM ON CONVEYOR BELT
제어로봇시스템학회 국제학술대회 논문집
2006 .10
-
GIS를 이용한 진동환경 관리시스템 개발
소음·진동
1997 .06
-
교통진동에 대한 중층건물의 진동특성
대한건축학회 학술발표대회 논문집 - 구조계
2005 .10
-
Binary 와 ternary granular mixture 거동에 관한 기초 연구
한국정밀공학회 학술발표대회 논문집
2010 .05
-
Vibration Optimum Design for Pump Rotors Using Genetic Algorithm
International Conference on Fluid Machinery
1997 .10
-
VIBRATION OF VIBRATORY GYROS WITH INPERFECTIONS
한국소음진동공학회 국제학술발표논문집
2008 .07
이 논문의 저자 정보
이 논문과 함께 이용한 논문
최근 본 자료
댓글(0)
0
UCI(KEPA) : I410-ECN-0101-2010-555-001452318