메뉴 건너뛰기
.. 내서재 .. 알림
소속 기관/학교 인증
인증하면 논문, 학술자료 등을  무료로 열람할 수 있어요.
한국대학교, 누리자동차, 시립도서관 등 나의 기관을 확인해보세요
(국내 대학 90% 이상 구독 중)
로그인 회원가입 고객센터 ENG
주제분류

추천
검색
질문

논문 기본 정보

자료유형
학술대회자료
저자정보
저널정보
대한기계학회 대한기계학회 춘추학술대회 대한기계학회 2007도 추계학술대회 강연 및 논문 초록집
발행연도
2007.10
수록면
120 - 124 (5page)

이용수

표지
📌
연구주제
📖
연구배경
🔬
연구방법
🏆
연구결과
AI에게 요청하기
추천
검색
질문

초록· 키워드

오류제보하기
Pb(Zr<SUB>0.52</SUB>Ti<SUB>0.48</SUB>)O₃ nanofibers with diameters ranging from 150nm to about 800nm were fabricated by electrospinning using PZT sol-gel as precursor. The spun nanofibers were sintered at three different temperatures (550℃, 650℃ and 700 ℃). The effects of solvent (PVAc) concentration, feeding rate and acidification (organic acid) of PZT sol-gel precursor on fiber diameter and microstructure of fibers were investigated by SEM and XRD. SEM revealed that concentrations of PVAc had influence on fiber diameter. The average diameter of the nanofibers increased with increasing PVAc concentration. However, the feeding rate had little influence on fiber diameter. The PZT fiber surface from PZT/ PVAc precursor containing acetic acid was smooth and no crack was on the surface which demonstrated the necessity of acidifying PZT precursor to get dense and crack free nanofibers while surface of fibers without acetic acid was rough and some cracks appeared on the surface. The analysis by XRD indicated that the precursor started to be transformed into perovskite phase at 550 ℃ and completed in range of 650 ℃ - 700 ℃.

목차

Abstract
INTRODUCTION
EXPERIMENTAL
RESULTS AND DISCUSSION
X-RAY DIFFRACTION ANALYSIS OF THE PZT FIBER
CONCLUSION
ACKNOWLEDGEMENT
REFERENCES

참고문헌 (0)

참고문헌 신청

함께 읽어보면 좋을 논문

논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!

이 논문의 저자 정보

이 논문과 함께 이용한 논문

최근 본 자료

전체보기

댓글(0)

0

UCI(KEPA) : I410-ECN-0101-2009-550-016063763