메뉴 건너뛰기
.. 내서재 .. 알림
소속 기관/학교 인증
인증하면 논문, 학술자료 등을  무료로 열람할 수 있어요.
한국대학교, 누리자동차, 시립도서관 등 나의 기관을 확인해보세요
(국내 대학 90% 이상 구독 중)
로그인 회원가입 고객센터 ENG
주제분류

추천
검색

논문 기본 정보

자료유형
학술저널
저자정보
Joon‑Young Heo (Inha University) Min‑Seok Baek (Inha University) Kwang‑Jun Euh (Korea Institute of Materials Science) Kee‑Ahn Lee (Inha University)
저널정보
대한금속·재료학회 Metals and Materials International Metals and Materials International Vol.24 No.5
발행연도
2018.1
수록면
992 - 1,001 (10page)

이용수

표지
📌
연구주제
📖
연구배경
🔬
연구방법
🏆
연구결과
AI에게 요청하기
추천
검색

초록· 키워드

오류제보하기
This study investigated the microstructure, tensile and fatigue properties of Al–5 wt.%Mg alloy manufactured by twin rollstrip casting. Strips cast as a fabricated (F) specimen and a specimen heat treated (O) at 400 °C/5 h were produced andcompared. In the F specimen, microstructural observation discovered clustered precipitates in the center area, while in theO specimen precipitates were relatively more evenly distributed. Al, Al 6 (Mn, Fe), Mg 2 Al 3 and Mg 2 Si phases were observed. However, most of the Mg 2 Al 3 phase in the heat-treated O specimen was dissolved. A room temperature tensile test measuredyield strength of 177.7 MPa, ultimate tensile strength of 286.1 MPa and elongation of 11.1% in the F specimen and167.7 MPa (YS), 301.5 MPa (UTS) and 24.6% (EL) in the O specimen. A high cycle fatigue test measured a fatigue limit of145 MPa in the F specimen and 165 MPa in the O specimen, and the O specimen achieved greater fatigue properties in allfatigue stress conditions. The tensile and fatigue fracture surfaces of the above-mentioned specimens were observed, and thisstudy attempted to investigate the tensile and fatigue deformation behavior of strip cast Al–5 wt.%Mg based on the fi ndings.

목차

등록된 정보가 없습니다.

참고문헌 (0)

참고문헌 신청

함께 읽어보면 좋을 논문

논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!

이 논문의 저자 정보

최근 본 자료

전체보기

댓글(0)

0