메뉴 건너뛰기
.. 내서재 .. 알림
소속 기관/학교 인증
인증하면 논문, 학술자료 등을  무료로 열람할 수 있어요.
한국대학교, 누리자동차, 시립도서관 등 나의 기관을 확인해보세요
(국내 대학 90% 이상 구독 중)
로그인 회원가입 고객센터 ENG
주제분류

추천
검색

논문 기본 정보

자료유형
학술저널
저자정보
김종성 (경희대학교 지능공정 및 제어 연구실) 허유 (경희대학교 공과대학 기계공학과)
저널정보
한국섬유공학회 한국섬유공학회지 한국섬유공학회지 제46권 제4호
발행연도
2009.1
수록면
215 - 221 (7page)

이용수

표지
📌
연구주제
📖
연구배경
🔬
연구방법
🏆
연구결과
AI에게 요청하기
추천
검색

초록· 키워드

오류제보하기
This research reports on the bundle drafting characteristics on the basis of a mathematical model describing the bundle flow dynamics. And the model parameters were experimentally measured or estimated. The kinematic viscosity of bundle was measured experimentally and the velocity variance parameter was estimated by comparing results from the experiment and from the simulation. The step response of the output bundle thickness to a step change in the draft ratio was applied. The kinematic viscosity of bundle was confirmed to be in the range between $0.5{\times}10^6$ and $8.0{\times}10^6cm^2/s$, which depends on the process conditions. As the draft ratio increases, the viscosity decreases dramatically in a low level of the draft ratio, but a draft ratio higher than 10 causes a very slow change in the viscosity, which is again affected by the roller setting. The kinematic viscosity remained, however, almost unchanged in the level of the roller setting longer than 45 mm. Under the draft ratio larger than 10, a high viscosity and a low velocity variance of constituent fibers had the effect to make the stability area narrower. Therefore the analysis results of bundle flow stability indicate that the draft ratio should be adjusted as small as possible in the high draft ratio level larger than 10 and the entanglement of the bundle be minimized for a large value of the velocity variance parameter, if the bundle flow system is maintained in a dynamic stable state.

목차

등록된 정보가 없습니다.

참고문헌 (0)

참고문헌 신청

함께 읽어보면 좋을 논문

논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!

이 논문의 저자 정보

최근 본 자료

전체보기

댓글(0)

0