지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술저널
- 저자정보
- 저널정보
- 한국콘크리트학회 International Journal of Concrete Structures and Materials International Journal of Concrete Structures and Materials Vol.13 No.4
- 발행연도
- 2019.5
- 수록면
- 473 - 489 (17page)
이용수
초록· 키워드
오류제보하기
A series of pullout tests were conducted to investigate the interface bond properties of seven types of steel fibres embedded in the magnesium phosphate cementitious matrix. The micromorphology of the interface transition zone between MPC and different types of fibres was examined by scanning electron microscope. Test results showed that smaller diameter steel fibres with brass coating surface achieved higher average bond strength, higher pullout energy per unit volume and a higher ratio of material use. The end hook deformation provided the mechanical bond locally whereas the deformation along the length of fibre provided the mechanical bond distributed along the fibre. The failure mode and group effect of steel fibres were also investigated and reported.
목차
Abstract
1. Introduction
2. Experimental Program
3. Evaluation Parameters of Pullout Behaviour
4. Results and Discussion
5. Conclusions
References
참고문헌 (45)
참고문헌 신청
Abdelrazig, B. E. I., & Sharp, J. H. (1985). A discussion of the papers on magnesia- phosphate cements b. Cement and Concrete Research, 15(5), 921?922.
Abdelrazig, B. E. I., Sharp, J. H., & El-Jazairi, B. (1988). The chemical composition of mortars made from magnesia-phosphate cement. Cement and Concrete Research, 18(3), 415?425.
Abdelrazig, B. E. I., Sharp, J. H., & El-Jazairi, B. (1989). The microstructure and mechanical properties of mortars made from magnesia-phosphate cement. Cement and Concrete Research, 19(2), 247?258.
ASTM C109/C109M-16a. (2016). Standard test method for compressive strength of hydraulic cement mortars (using 2-in. or [50-mm] cube specimens). West Conshohocken: ASTM International. http://www.astm.org.
Banda Technology Co., Ltd. of Liaoning, China. Retrieved November 2018 from http://www.lnpdk j.com/. (in Chinese).
Abdelrazig, B. E. I., Sharp, J. H., & El-Jazairi, B. (1988). The chemical composition of mortars made from magnesia-phosphate cement. Cement and Concrete Research, 18(3), 415?425.
Abdelrazig, B. E. I., Sharp, J. H., & El-Jazairi, B. (1989). The microstructure and mechanical properties of mortars made from magnesia-phosphate cement. Cement and Concrete Research, 19(2), 247?258.
ASTM C109/C109M-16a. (2016). Standard test method for compressive strength of hydraulic cement mortars (using 2-in. or [50-mm] cube specimens). West Conshohocken: ASTM International. http://www.astm.org.
Banda Technology Co., Ltd. of Liaoning, China. Retrieved November 2018 from http://www.lnpdk j.com/. (in Chinese).
함께 읽어보면 좋을 논문
논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!
-
Pull-Out Behaviour of Hooked End Steel Fibres Embedded in Ultra-high Performance Mortar with Various W/B Ratios
International Journal of Concrete Structures and Materials
2017 .06
-
Investigating the Hybrid Effect of Micro-steel Fibres and Polypropylene Fibre-Reinforced Magnesium Phosphate Cement Mortar
International Journal of Concrete Structures and Materials
2022 .09
-
Numerical modelling of the pull-out response of inclined hooked steel fibres
Advances in concrete construction
2015 .01
-
Fast classification of fibres for concrete based on multivariate statistics
Computers and Concrete, An International Journal
2017 .01
-
Compressive strength and failure behaviour of fibre reinforced concrete at elevated temperatures
Advances in concrete construction
2015 .01
-
Comparison of macrosynthetic and steel FRC shear-critical beams with similar residual flexure tensile strengths
Structural Engineering and Mechanics, An Int＇l Journal
2020 .01
-
Formula to identify the Influence of steel fibres on the mechanical properties of HPC
Computers and Concrete, An International Journal
2020 .01
-
Crack Propagation Analysis of Synthetic vs. Steel vs. Hybrid Fibre-Reinforced Concrete Beams Using Digital Image Correlation Technique
International Journal of Concrete Structures and Materials
2020 .11
-
Experiments on Tensile and Shear Characteristics of Amorphous Micro Steel (AMS) Fibre-Reinforced Cementitious Composites
International Journal of Concrete Structures and Materials
2017 .12
-
Experimental and microstructural evaluation on mechanical properties of sisal fibre reinforced bio-composites
Steel and Composite Structures, An International Journal
2019 .01
-
Prediction of Hybrid fibre-added concrete strength using artificial neural networks
Computers and Concrete, An International Journal
2015 .04
-
Behaviour of Carbon and Basalt Fibres Reinforced Fly Ash Geopolymer at Elevated Temperatures
International Journal of Concrete Structures and Materials
2018 .05
-
Mechanical behaviour of steel fibre reinforced SCC after being exposed to fire
Advances in concrete construction
2018 .01
-
Experimental evaluation on comparative mechanical properties of Jute – Flax fibre Reinforced composite structures
Structural Engineering and Mechanics, An Int＇l Journal
2020 .01
-
Effect of fibre loading and treatment on porosity and water absorption correlated with tensile behaviour of oil palm empty fruit bunch fibre reinforced composites
Advances in materials research : AMR
2017 .01
-
Behaviour of hybrid fibre reinforced concrete beams strengthened with GFRP laminates
Structural engineering and mechanics : An international journal
2018 .01
-
Bond strength characterization and estimation of steel fibre reinforced polymer - concrete composites
Steel and Composite Structures, An International Journal
2022 .09
-
Fibrin affects short-term in vitro human mesenchymal stromal cell responses to magneto-active fibre networks
Biomaterials and biomedical engineering
2015 .01
-
Flexural behaviour of fibre reinforced geopolymer concrete composite beams
Computers and Concrete, An International Journal
2015 .03
-
Shear and impact strength of waste plastic fibre reinforced concrete
Advances in concrete construction
2017 .01
이 논문의 저자 정보
최근 본 자료
댓글(0)
0