지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
이용수
이 논문의 연구 히스토리 (2)
- 이 논문의 후속연구가 궁금하신가요?
- 연관 학술논문 또는 학술발표를 통해 보다 발전된 연구결과를 확인하실 수 있습니다.
- 이 논문의 연구 히스토리 확인하기
초록· 키워드
오류제보하기
An automatic grease lubricator provides an adequate amount of fresh grease constantly to any type of rotating machine to minimize friction heat and reduce friction loss. This study seeks to develop an automatic grease lubricator by means of rapid prototyping with a gear-driven mechanism and a controlled operation time. The ultimate design is to lubricate an adequate amount of grease by a simple dip-switch clicking mechanism according to an advanced set cycle. The backlash of the gear was minimized to increase the power, and to increase the power of the mechanism, the binding frequency and the thickness of the coil were changed. To control the rotation cycles of the main shaft according to certain set numbers, different resistances and chips were used in the design of the circuit which controls the electrical signals via a pulse. A digital mock-up was analyzed and the rapid prototyping (RP) trial products were tested with a PCB circuit and grease. An evaluation of the outlet capacity of RP trial products was conducted, as the friction caused by the outlet on the wall surface was an important factor in the operation of the equipment. Finally, a finishing process was applied to decrease the roughness of a surface to a comparable level to test the performance of the product.
목차
ABSTRACT
1. 서론
2. 기어구동방식의 주유기 설계
3. 쾌속조형기에 의한 시제품 제작과 토출 실험결과
4. 결론
REFERENCES
참고문헌 (3)
참고문헌 신청
1. [학술지(정기간행물)] - 김원중 / 2012 / RP시스템을 이용한 원형시제품 제작 시 제품 오차 보정에 관한 연구 / 한국기계가공학회지 11 (3) : 146 ~ 153
2. [학술대회논문] - H. J. Yang / 2001 / A research on postprocessing finishing method of the rapid prototyping parts / Proceedings of 2001 Autumn Conference : 83 ~ 86
3. [학술대회논문] - J. U. Jun / 2002 / Influence of tangent line angle on surface roughness at fused deposition / Proceedings of 2002 Spring Conference : 1067 ~ 1070
2. [학술대회논문] - H. J. Yang / 2001 / A research on postprocessing finishing method of the rapid prototyping parts / Proceedings of 2001 Autumn Conference : 83 ~ 86
3. [학술대회논문] - J. U. Jun / 2002 / Influence of tangent line angle on surface roughness at fused deposition / Proceedings of 2002 Spring Conference : 1067 ~ 1070
이 논문의 저자 정보
이 논문과 함께 이용한 논문
최근 본 자료
댓글(0)
0
UCI(KEPA) : I410-ECN-0101-2016-581-001043411