지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술대회자료
- 저자정보
- 저널정보
- 한국소성·가공학회 기타자료 The 8th International Conference and Workshop on numerical simulation of 3D seet metal forming processes (NUMISHEET 2011)
- 발행연도
- 2011.8
- 수록면
- 997 - 1,003 (7page)
이용수
초록· 키워드
오류제보하기
In the deep drawing of cups, the earing defects are caused by planar anisotropy in the sheet. Several methods have been developed to predicting the optimal blank to avoid the formation of ears. In the deep drawing processes, the use of an optimal blank shape not only saves the material but also it may reduce the occurrence of defects e.g. wrinkling and tearing. In addition, finding the desirable flange contour, eliminate the trimming step in the deep drawing of parts with flange. In this study, a systematic method based on sensitivity analysis has been used to find the optimal blank to obtain a desirable flange contour for a cylindrical cup by hydromechanical deep drawing process. With the aid of a well-known dynamic explicit analysis code ABAQUS; optimum initial blank shape has been obtained. With the predicted optimal blank, both computer simulation and experiment are performed and the effect of blank shape on the some parameters such as thickness distribution and blank holder force during the forming process were investigated. It is shown that formed cup with an optimum blank shape has a better thickness distribution in the both rolled and perpendicular of rolled direction. And it was shown that the blank holder force of modified blank is higher than circular blank.
목차
Abstract
INTRODUCTION
OPTIMIZATION PROCEDURE
FINITE ELEMENT SIMULATION
RESULTS OF SIMULATION
EFFECT OF BLANK SHAPE ON THICKNESS DISTRIBUTION
EFFECT OF BLANK SHAPE ON BLANK HOLDER FORCE
CONCLUSION
REFERENCES
참고문헌 (0)
참고문헌 신청이 논문의 저자 정보
최근 본 자료
댓글(0)
0