지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
이 논문의 연구 히스토리 (2)
- 이 논문의 후속연구가 궁금하신가요?
- 연관 학술논문 또는 학술발표를 통해 보다 발전된 연구결과를 확인하실 수 있습니다.
- 이 논문의 연구 히스토리 확인하기
초록· 키워드
오류제보하기
With the increasing power demands, size of the fault current in electrical grids is steadily increasing, and it exceeds the breaking capacity of circuit breakers. To effectively cope with these problems, a high-speed interrupter was suggested. The high-speed interrupter provides fault current with a bypass to a fault current limiter in case of accidents and consequently, fault current can be restricted. In this study, behavioral characteristics of high-speed interrupter were analyzed by accident types occurred in a distribution system. When accidents occurred, a and b contact of the high-speed interrupter were turned-off and then, turned-on. Accordingly, fault current flowed to the circuit connected to a current limiting element, and the fault current limiter restricted fault current to within a half-cycle. Nevertheless, the behavior of the high-speed interrupter was slowed down by a switching surge. As a result, fault current was confirmed to be restricted not to within the anticipated half-cycle, but to after a half-cycle. Moreover, the behavioral characteristics of the high-speed interrupter changed not only by accident types, but by behaviors of R, S, and T phases. This was due to the errors in stroke lengths of the high-speed interrupters, which resulted in a slight time discrepancy among three interrupters. In addition, the switching behaviors of the b and a contact were confirmed not to have coincided due to the switching surge; b contact behaved first and a contact followed. because of this, accuracy of stroke length and switching surges through the solenoid suction increases may be necessary to resolve.
목차
Abstract
1. 서론
2. 본론
3. 결론
References
참고문헌 (7)
참고문헌 신청
1. [학술지(정기간행물)] - H. S. Choi / 2002 / Switching properties of hybrid type superconducting fault current limiter using YBCO stripes / IEEE Trans, on Appl. Superconduct 12 : 1833 ~ 1838
2. [학술지(정기간행물)] - H. S. Choi / 2007 / Operating Performance of the Flux-Lock and the Transformer Type Superconducting Fault Current Limiter Using the YBCO Thin Films / IEEE Trans, on Appl. Superconduct 17 : 1823 ~ 1826
3. [학술지(정기간행물)] - R. Kreutz / 2005 / System technology and test of curl 10, a 10 kV, 10 MVA resistive high-Tc superconducting fault current limiter / IEEE Trans. on Appl. Superconduct 15 : 1961 ~ 1964
4. [학술지(정기간행물)] - M. H. Kim / 2010 / Method of recloser-fuse coordination in a power distribution system with superconducting fault current limiter / IEEE Trans. on Appl. Superconduct 20 : 1164 ~ 1167
5. [학술지(정기간행물)] - O. B. Hyun / 2009 / Introduction of a Hybrid SFCL in KEPCO Grid and Local Points at Issue / IEEE Trans. on Appl. Superconduct 19 : 1946 ~ 1949
2. [학술지(정기간행물)] - H. S. Choi / 2007 / Operating Performance of the Flux-Lock and the Transformer Type Superconducting Fault Current Limiter Using the YBCO Thin Films / IEEE Trans, on Appl. Superconduct 17 : 1823 ~ 1826
3. [학술지(정기간행물)] - R. Kreutz / 2005 / System technology and test of curl 10, a 10 kV, 10 MVA resistive high-Tc superconducting fault current limiter / IEEE Trans. on Appl. Superconduct 15 : 1961 ~ 1964
4. [학술지(정기간행물)] - M. H. Kim / 2010 / Method of recloser-fuse coordination in a power distribution system with superconducting fault current limiter / IEEE Trans. on Appl. Superconduct 20 : 1164 ~ 1167
5. [학술지(정기간행물)] - O. B. Hyun / 2009 / Introduction of a Hybrid SFCL in KEPCO Grid and Local Points at Issue / IEEE Trans. on Appl. Superconduct 19 : 1946 ~ 1949
이 논문의 저자 정보
이 논문과 함께 이용한 논문
최근 본 자료
댓글(0)
0
UCI(KEPA) : I410-ECN-0101-2014-560-000448280