개인구독
소속 기관이 없으신 경우, 개인 정기구독을 하시면 저렴하게
논문을 무제한 열람 이용할 수 있어요.
지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술저널
- 저자정보
- 발행연도
- 2009.3
- 수록면
- 65 - 74 (10page)
이용수
초록· 키워드
오류제보하기
Device quality indium tin oxide (ITO) films are deposited on glass substrates and ultra-thin diamond-like carbon films are deposited as a buffer layer on ITO by a pulsed Nd:YAG laser at 355 ㎚ and 532 ㎚ wavelength. ITO films deposited at room temperature are largely amorphous although their optical transmittances in the visible range are ＞ 90%. The resistivity of their amorphous ITO films is too high to enable an efficient organic light-emitting device (OLED), in contrast to that deposited by a KrF laser. Substrate heating at 200℃ with laser wavelength of 355 ㎚, the ITO film resistivity decreases by almost an order of magnitude to 2×10<SUP>-4</SUP> Ω ㎝ while its optical transmittance is maintained at ＞ 90%. The thermally induced crystallization of ITO has a preferred 〈111〉 directional orientation texture which largely accounts for the lowering of film resistivity. The background gas and deposition distance, that between the ITO target and the glass substrate, influence the thin-film microstructures. The optical and electrical properties are compared to published results using other nanosecond lasers and other fluence, as well as the use of ultra fast lasers.
Molecularly doped, single-layer OLEDs of ITO/(PVK+TPD+Alq₃)/Al which are fabricated using pulsed-laser deposited ITO samples are compared to those fabricated using the commercial ITO. Effects such as surface texture and roughness of ITO and the insertion of DLC as a buffer layer into ITO/DLC/(PVK+TPD+Alq₃)/Al devices are investigated. The effects of DLC-on-ITO on OLED improvement such as better turn-on voltage and brightness are explained by a possible reduction of energy barrier to the hole injection from ITO into the light-emitting layer.
Molecularly doped, single-layer OLEDs of ITO/(PVK+TPD+Alq₃)/Al which are fabricated using pulsed-laser deposited ITO samples are compared to those fabricated using the commercial ITO. Effects such as surface texture and roughness of ITO and the insertion of DLC as a buffer layer into ITO/DLC/(PVK+TPD+Alq₃)/Al devices are investigated. The effects of DLC-on-ITO on OLED improvement such as better turn-on voltage and brightness are explained by a possible reduction of energy barrier to the hole injection from ITO into the light-emitting layer.
목차
Ⅰ. INTRODUCTION
Ⅱ. EXPERIMENTAL
Ⅲ. RESULTS AND DISCUSSION
Ⅳ. CONCLUSIONS
ACKNOWLEDGMENTS
REFERENCES
참고문헌 (0)
참고문헌 신청이 논문의 저자 정보
최근 본 자료
댓글(0)
0